Perform a measurement just after the machine has been shut off and another when the machine is cold. The Hot Check program is used to compare these two measurements. The difference between the two measurements can be used as target values when shaft alignment is performed

Paired with Acoem’s Offset Fixtures, this program allows users to precision align an offset mounted machine with confidence.

Align a setup of more than two rotating machines that are connected to each other.

For machines driven by spacer shafts (or membrane couplings), this specialized program will guide the user through the alignment process.

Once you have determined the machine’s thermal expansion, this program will allow you to pre-set target values prior to starting your alignment work.

Check if there is a soft foot condition to verify if the motor is not resting firmly on all its feet.

Using the Acoem T21 rectangular flatness sensor when paired with the M9 sensor, the deviation in distance between the laser plane and the measurement object can be measured in one or more positions.

Determine and correct the relative position of two vertically/flange-mounted machines that are connected, so that the rotational centers of the shafts are collinear.

Determine and correct the relative position of two horizontally mounted machines that are connected, so that the rotational centers of the shafts are collinear.