Posts Tagged ‘OneProd Falcon’
Adding Process Points to a Data Collection Route
Sometimes other data can influence analysis when running your regular routes. This data can range from discharge pressure on pump to slide valve position on a chiller or maybe just bearing temperature just to name a few. With the Falcon and Nest this type of data can be collected and even trended in the Nest.…
Read MoreBalancing How To #5 – How A Correction Weight and Location is Calculated
In our last “How To” we talked about the trial run – using a trial weight and location, to calculate the amount and location of a correction weight, which should correct the unbalance. Most modern-day balancing tools do the math for you. Even though these tools calculate the correction weight and location, it is good…
Read MoreProper RPM Set Up with the OneProd Falcon
One key bit of data required when collecting data or analyzing it is accurately pinpointing the RPM. When we set up schematics in the Machine Set Up module we tell the software what the RPM is here. When setting up a machine in the Nest you can choose either fixed speed, variable speed with keyboard,…
Read MoreChanging ONEPROD FALCON Settings for Hard-Wire Sensors
From time to time, when performing route-based vibration analysis, you run across situations where access is limited to a data collection point. For example, this large pump below. Climbing up a structure to collect vibration data is unsafe and keeping a ladder stationed nearby can cause headaches as well. A simple solution is to permanently…
Read MoreAdding Machines to an Existing Route in Your Nest Software.
Sometimes machines need to be added to a route that is already established. This is quite easy to do in the Nest. After you have collected all the pertinent information including machine name, RPM and horsepower (at a minimum) go into your Nest home screen and select “set up machine”. Once into machine set up…
Read MoreBalancing How To #1 – Setting Up for Balancing
The recent blog on troubleshooting balancing ( https://acoem.us/other-topics/smc-touch-tip-using-the-smc-when-unbalance-is-diagnosed/ ) brought up some additional questions from our readers, so let’s tackle them in order. The first one is setting up to perform a balance job. NECESSARY EQUIPMENT FOR BALANCING If you have gone through the checklist and confirmed unbalance, you will need: A machine to perform…
Read MoreSeal Failures Caused by Base Issues
Taking the ONEPROD Falcon to the field is a big part of the 2-day training we provide on our entire Falcon line of condition monitoring tools. When we go to the field we always find interesting issues to analyze and discuss. A recent check of a centrifugal pump yielded one of those issues. The pump…
Read MoreMechanical Looseness Identification
A common vibration signature on equipment is looseness. There are two types of looseness: structural/fastener, fit between rotating components. For this discussion, we will focus on structural and fastener looseness. Typically, it is highly directional, occurs at 1xRPM, and will look similar to this spectrum. In this case, the vibration was confined to the vertical…
Read MoreShock Factor and SFI
For years, vibration analysts have depended upon the ISO Vibration Severity Chart for the determination of machinery health. Typically, this chart provides a level of certainty that would allow the analyst to look at the vibration levels, and if acceptable, move onto the next machine for analysis. Some defects are determined in the waveform…
Read MorePaper Machine Vibration Data Collection
As my grandma used to say, “When you don’t know how to use your head, you’d better know how to use your legs”. Thanks to a feature on our FALCON data collector I didn’t have to call her to tell her how right she was (again)! Two of us were performing data collection on a…
Read More