A common source of frustration during the precision alignment process is, how can we make a controlled move when making the horizontal adjustment? We trainers often hear our clients say they don’t have jacking bolts, or pushers, etc. There have been numerous excellent blogs written on the subject of jack bolts.

Pry bars, sledge hammers and come alongs – Stan Riddle 07/16/2015

Use your head not your hammer – Tom Shelton 10/02/2014

Back off jack bolts – Brad Case 12/14/2016

Installation errors – Tom Shelton 09/20/2018

Allow me to make one more suggestion. At times there are situations where time, conditions or company policy may not be conducive for installation of permanent jack bolts.

The above picture is of one of the Side Align Tool Sets available in the VibrAlign store.

The Side Align Tool Sets provide you with the ability to make precise horizontal adjustments within .001 inches or closer. They are available for securing bolt sizes from 3/8” to ¾” (AT-1104) or 3/8” to 1-1/4” (AT-1108), as well as individually as replacements.


These durable alignment tools add efficiency to an otherwise tedious, painstaking task. This tool set has been the answer for several clients I have been privileged to conduct training for.

Share Blog Post


  1. Brian meister on February 13, 2019 at 11:54 am

    How much is a set of those as a union millwright I come across this problem more often then I care to say

  2. Mac MacCormack on February 18, 2019 at 7:58 am

    Brian, check out our online store via the link below for prices on the SideAlign sets as well as undercut bolts and hardened alignment washers.


Subscribe to the
Acoem USA Blog

  • This field is for validation purposes and should be left unchanged.