Anyone involved in precision shaft alignment knows that unintentional movement is the biggest contributor to non-repeatable alignment results. Movement can come from several sources: Soft foot, loose bolts, flexible bases, excessive bearing clearances, improperly mounted or loose sensor mounting hardware, etc. One of the more elusive and least considered sources of movement is cupped washers…
Read More
During the OJT portion of a Fixturlaser NXA Pro training class, at a power plant, the students asked me to allow them to perform the precision laser shaft alignment of a 75 HP electric motor to pump without interrupting them or offering any advice. I obliged and let them go on their way. The first…
Read More
While assisting a recent Fixturlaser NXA Training Class with a precision shaft alignment we came across an unusual alignment challenge. When tightening the hold down bolts, after making a Verti-Zontal Compound MoveTM, we were seeing insignificant amounts of horizontal movement at the motor feet but nothing unusual. However, upon rechecking the alignment, we were out of…
Read More
The belly of your electric motor that is! During the OJT portion of a training class, at an Omaha NE client, I ran into a most extreme case of soft foot. The customer told me they had a motor/pump set that they could not align no matter what. This was a 100 HP electric motor…
Read More
In my previous blog entry “Why do people struggle with alignment? Part 1”, we discussed the importance of not only micing, cleaning, and consolidating shims but also noting the total amount of shims under each foot of the movable machine. The motor-pump set we performed an alignment check on, had the following amount of shims…
Read More
After a shaft alignment check, if it’s out of tolerance, some maintenance personnel will skip the pre-alignment checks and proceed directly to correcting the vertical and horizontal misalignment. Frustration begins to set in as the alignment results go back and forth and seem inconsistent. The laser shaft alignment instrument says to add 20 mils to the…
Read More
During the classroom portion of a Fixturlaser GO Pro training class, at a sheet metal processing plant, one mechanic insisted the GO Pro alignment results were not repeatable in the field. The mechanic had the opportunity to use their GO Pro once before the training class and was convinced it would not repeat For the…
Read More
During a recent Fixturlaser GO Pro Training class, at a mid-west university, we performed a shaft alignment on a large Flowserve HVAC pump with a 500 HP electric motor. This motor was large enough that multiple people could work on both sides without really seeing each other. Well, that proved to be an issue with…
Read More
During a recent Fixturlaser XA Pro training class, at a Texas petrochemical plant, we were performing an alignment on a 25 HP, 3600 RPM electric motor & water pump. At first the class was having a little trouble bringing the alignment into the 3600 tolerance due to two separate issues. The first was severe vibration…
Read More
A recent Fixturlaser GO Basic Training class performed a field alignment on a 100 HP, 3 Phase, 5600 RPM electric motor coupled to a crude oil pump in a refinery. The class decided it would be permissible to use the 3600 RPM setting in GO Basic active tolerance table, which is +/- 0.5 mils/1” angular…
Read More
During the OJT portion of a Fixturlaser GO Basic Training class, with the Army Corp of Engineers, the class aligned two electric motors driving large winch gearboxes on a dredging barge. These winches are used to move the barge into position during dredging operations. The class wanted to rotate both shafts to perform the alignments,…
Read More
If you’re working to maintain machines, Acoem USA wants to help.
We’re committed to providing tools, training, and services that will transform your approach to maintenance and reliability.
